About this 3D model

The Knightrunner Pop Up Camper was designed to fit into the bed of the Element Knightrunner. It will need to be glued to the bed with Shoe Goo or E6000 and we recommend using rear magnet mounts to make removal of the body easier. This set also comes with a short Front Runner rack and non working light set to complete the look. PLEASE NOTE: The Pop Up tent part of the assembly comes in a larger sections and is also broken into smaller sections to make it easier to print on smaller printer beds. You will need magnets to latch the Pop Up tent closed. We recommend using the following magents glued in place with Shoe Goo (both sold separately). 1/2 x 1/4 x 1/8 Inch Strong Neodymium Rare Earth Ring/Donut Magnets N48 (20 Pack) Link: totalelement.com/products/1-2-x-1-4-x-1-8-inch-neodymium-rare-earth-ring-magnets-n48-20-pack The 2D template to create the soft canvas part of the tent can be found by clicking on the dropbox link below (all dimensions in mm): https://www.dropbox.com/sh/37o3qyhf0twi2y1/AAD0XBEWMhFD0DbLl429vWKQa?dl=0