About this 3D model

Summary I was getting annoyed with my Ikea Tradfri dimmer being stuck to the wall. I was getting even more annoyed with visitors turning off the lights at the switch, thus killing power to the bulbs and preventing them from being turned on again with the gateway. So, the switch cover was born. I wanted to be able to access the switches if I needed to and so there is a small hole that enables a screwdriver to pop the dimmer out. There are two version. One which can be printed as a single part (with lots of supports), and a split version that only needs a little bit of support in the middle of the adapter part. Print Settings Supports: Yes Resolution: 0.2 Infill: 20% Notes: Supports needed for the combined version and the plate of the split version.