About this 3D model

WARNING, this is a hard project but very rewarding when completed. 9 Plates total. Print 6 background plates in grayscale and glue onto a black posterboard, then print red plate, teal jacket, words and glue onto the background. I actually prefer the colors to stick off above the background for an even better depth. ***Does not fit perfectly, trimming of the colored pieces is necessary if you want them to fit together flush** Print ALL plates at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Grayscale Background (6 plates) : Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Steel Grey At layer #11 (0.96mm) swap to Grey At layer #16 (1.36mm) swap to White for the rest. Red Cross (1 plate): Swap Instructions: Start with Black At layer #4 (0.4mm) swap to Red At layer #9 (0.8mm) swap to Steel Grey At layer #14 (1.2mm) swap to Ash Gray At layer #19 (1.6mm) swap to White for the rest. Teal Jacket (1 plate): Swap Instructions: Start with Black At layer #5 (0.48mm) swap to Green At layer #9 (0.8mm) swap to Grass Green At layer #11 (0.96mm) swap to Aqua Blue At layer #16 (1.36mm) swap to Jade White for the rest. TRAUMA TEAM words (1 plate): Swap Instructions: Start with Black At layer #3 (0.32mm) swap to Red At layer #10 (0.88mm) swap to Aqua Blue At layer #15 (1.28mm) swap to Grey At layer #19 (1.6mm) swap to White for the rest.