About this 3D model

This is a remix of Helichrissi's Mavic Air 2 phone holder design. My goal for this remix was to make the holder a little more sturdy by adding more screws. I also wanted to create one that was slightly larger to accommodate my phone with an Otterbox case. I added four screws to attach the lower part of the holder to the base and also added a center screw to attach a clamp to keep the base from slipping off the controller. Finally, I designed a thumbscrew to allow for toolless assembly and disassembly of the mount. What to Print 1 -Base 1 - Holder Bottom (either regular or large but not both) 1 - Adjustable Slider (either regular or large but not both) 1 - Clamp 2 -Thumb Screw Additional Supplies Needed 4 - M3 x 12MM Socket Head Cap Screws 4 - M3 Nuts 1 - M4 x 30MM Socket Head Cap Screws 4 - M4 Nuts Print Settings Printer Brand: Creality Printer: CR10S PRO Rafts: Doesn't Matter Supports: Yes Resolution: 0.2 Infill: 30% Filament: Hatchbox PLA Grey Notes: I used rafts because I was getting some warping on the larger parts; however, they may not be required if you have a different setup. Category: R/C Vehicles