About this 3D model

This is my first Fusion 360 model, so don't be too harsh with your comments. I made this because I gave my mother a tube squeezer but she wanted a smaller one. I searched for the correct size but could not find one, so searched for parametric designs. I found one parametric design, but when adjusting the parameters I broke the 3d model, so had to design one myself. The table below (and the last picture) show what parameters are used: Variable Value or Formula Calculated Description cBodyAxis cTriangleSide * 1 20.5 mm Calculated length of middle axis, a factor (Minimal 1) times TriangleSide cTriangleSide vTriangleFillet + vMeatTriangleFilletSlotFillet + vSlotFillet + 0.5 * vSlotLength 20.5 mm Calculated Triangle Side vEdgeFillet 1 mm - Fillet of the top and bottom sides vEdgeToSlot 2 mm - Distance from edge to slot vMeatTriangleFilletSlotFillet 3 mm - Distance between TriangleFillet and SlotFillet vSlotFillet 0.5 mm - Fillet of the slot itself vSlotLength 28 mm - Length of the slot vSlotWidth 1.5 mm - Width of the slot vThickness 5 mm - Thickness of the whole body vTriangleFillet 3 mm - Fillet of the 3 corners of the body Variables starting with c are calculated and should not be modified with the exception of the cBodyAxis formula. Here the factor 1 is used which basically impacts the middle axis (cBodyAxis) allowing you to enlarge the part you grip when sliding the squeezer up and down the tube. Variables starting with v can be modified to your likings; keep in mind that you might end up with a broken 3d model when certain parameter values don't work together. The EH_Tube_Squeezer_02.stl file uses the parameters as shown in the table above.