About this 3D model

Added an additional version with holes for hooking in a lanyard, figured that would be useful for using as a power tap and having a wire to connect to whatever you're powering, takes some weight off the tool… or just to secure a spare battery to your belt or other equipment. Check the files section. This is an adaptation of my M18 wall mount, this one has provisions for power leads for using m18 batteries as accessory power, i designed it to fit a male blade connector with the insulator removed, i intend to solder wire in to the connector, then run the wire through the hole, and glue in to place, make sure you add a switch and fuse, maybe a low voltage cutoff, there are just too many options for those so i didn't build them in to this model.