About this 3D model

The one and only!! :) The iconic tricycle that millions of children had during their youth !!!Easy to print, simple to assemble!! Approx 220mm (9 in) in length fully assembled. Some supports, but very few. (handlebars and backrest only) You will need some m5 screws:(3x) m5 x 25mm Some glue. That's it!! Assembly instructions included in five easy steps. All parts are already placed in the right orientation for printing. Have fun printing and enjoy this baby!!! No commercial use allowed 3D PRINTING SETTINGSParts needing supports: -Backrest, only for the two posts-Handlebars. This part was supposed to be support free BUT!!: Put supports on the "handle section" only, each side, to prevent the small section from breaking while printing.The surface area of the tip of the handle is very small, and until it reaches the center part at the top, its pretty easy to break while printing.A brim won't do it, i've tried and it failed 3 times.