About this 3D model

The 2019 Deckard Sedan A decommissioned police Aerodyne retrofitted to ground mode. NOTES: I separated the front wheels to minimize distortion while printing. You'll need to print two copies of the wheel model and glue them in place. I hollowed out the underside of the vehicle to save on resin/filament.There's enough room underneath to add in some LEDs if you're so inclined. I have not included a supported version as its a fairly large model and you might prefer a different print orientation depending on your printer. I rotated the model 25 degrees with the rear facing up and added supports underneath. I have only printed this out in resin so far, but I'm sure that with some proper orientation it will print just fine on an FDM printer with minimal supports.