About this 3D model

From my campaign Ks: Tree Village The Carpenter's Workshop working Printed with Ender3 My settings : Cura slicer- Nozzle 0,4mm- Pla 1,75mm- Layer 0,2mm- 5% infill- Walls 1mm- Support overhang angle from 80° to 86° (depend by the model)- Support Z distance 0,3 To reduce the supports to the maximum I printed everything with an overhang between 80° - 86 °,even if the supports are generally few and sometimes absent, you must leave the "generate supports" option in your slicer always active to allow those small parts need to be supported to print well.I found the "support Z distance " setting in the supports section very important, because it allows us to distance the top of the support from the model a bit (my value 0.3mm) With a print bed of 20x20x20cm each piece will fit well Fabio