About this 3D model

This is a simple set of clamps for the ANT Compact PCB Maker . They secure the bottom of the NEMA 11 stepper motors against the MakerBeam frame. Without something to do this, any tension put into the belts will tend to deflect the motors away from the frame. Installation Insert a MakerBeam square headed bolt into the frame. Place the screw hole of the printed part over the bolt and the semi-circular tab into the hole on the bottom of the stepper motor. Place a washer over the bolt Tighten the printed part against the frame with a nylock nut. Print instructions Recommended to print in the orientation provided for strength and durability. Will benefit from supports due to the print orientation.