About this 3D model

Drum sanding attachment for your powerdrill. External Hardware: 2x 608 Bearing 1x M8 nut 1x M8 threaded Rod (90mm + Drumheight) Print Settings: 0,2mm Layerheight, 4 perimeter, 20% Infill Assembly: Add 608 Bearing to the upperside of the handle (press fit) Ad 608 Bearing to the inside of the handle (press fit) Add M8 threaded rod to the drum. If it's too tight by hand use your powerdrill to thread it in. The rod should be 90mm + drum height in total length. If it's too loose or get loose during work, secure it with a little bit of superglue. Put the drumassembly into the handle. Make sure the side with the small circular extend faces the bearing. Add the M8 nut and tighten it. Now you can also put on the cap for the handle Add the sandpaper Lock the sandpaper into place by rotating the locking mechanism about 90° with an 6mm allen key. When the locking mechanism is not loose in the first place, by rotating it with the allen key it should get loose. Info: You find various drum sizes in the raw files. If you need a different height, just leave me a message and I will add it.