About this 3D model

Lightweight glider for Indoor and Outdoor Fun Hand-, Crossbow-, or Rubber band start possible Easy and fast print Print Settings: Layer height: 0.12mm works best, 0.06mm are also ok Infill: 100% Outer Lines: Min 2 Placement: Glider is rotated 45° in z-axis so that the infill of the first layer goes along the wings. This gives some rigidity when bending the wings and stabilizers. Also a practical tool to calibrate your first layer and test layer adhesion. Preparations: Stick the vertical stabilizer into the slot in the fuselage or bend the horizontal stabilizers to a v-tail configuration. Bend wings slightly upwards Bend tail slightly upwards directly behind the wings. Launch: Hand launch Grip between wings and tail or with your index finger on the rubber band notch and throw gently Gummi band launch Hold the band as you like Place sling on edge on the bottom Shoot Catapult start Place plane with edge directly on the sling Shoot