About this 3D model

An interpretation of Starry Night by Van Gogh made for filament painting. I tried hueforging an image of the original oil on canvas as well, but the outcome didnt look as good due to the nature of the brushstrokes. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: Generic Black, Blue, Light Blue, Orange, Yellow, White PLA+ filaments. Swap Instructions: Start with Black At layer #3 (0.32mm) swap to Blue At layer #8 (0.72mm) swap to Light Blue At layer #13 (1.12mm) swap to Orange At layer #19 (1.6mm) swap to Yellow At layer #31 (2.56mm) swap to White for the rest. Two print profiles have been provided as 6 colors are used: for use with 2 or more AMS units for use with a single AMS unit The only difference is that the single AMS profile has been set to swap back to slots 1 and slot 2 after printing from slot 4. A pause has been added before the end of the 4th color (orange) to allow for slots 1 and 2 to be changed from Black and Blue to Yellow and White respectively. In summary the print order will be Slot 1 → Slot 2 → Slot 3 → Slot 4 → Slot 1 → Slot 2. UPDATE : An updated experimental print profile has been uploaded with less orange and yellow. Try only if your orange/yellow filaments have a high opacity, causing the picture to look too warm. Protip: Reducing nozzle temps slightly (5 - 10 degrees C) may help prevent stringing on detailed prints like this that require lots of retractions. Happy printing! Share your makes! Note: Bambu Studio shows Error 920 : Non-manifold edges when slicing. This is normal for Hueforge prints. Please ignore and print away :)