About this 3D model

Another attempt at HueForge earrings! This design was created in Craiyon.com . It was then run through HueForge . I then shaped it in the Bambu Slicer as the original shape was square. The prompt was “Abstract Sun”, but it also kind of looks almost like an eye. Regardless, I thought it was pretty fun! I did it in sun colors, but I think it could be fun in other colors like shades of blue! Printed pieces are attached to an ear wire using 2 jump rings to get them to hang right. Layer changes - swatches also shown in images. If you are using a single AMS (like me) have the White be the same slot as Black and as soon as the black finishes, swap out the rolls. Layers 1 - 9 : Black Layers 10 - 12 : Orange [Creality Pro Orange(Pumpkin)] Layers 13 - 15 : Red (Inland Red) Layers 16 - 20 : Gold (Matterhackers Gold) Layers 21 - Top : White .08mm Extra Fine settings were used with .4 Nozzle. Ironing was used on ALL top surfaces, but this can be a matter of preference. Gyroid infill is used where it is necessary but 100% infill could also be good with how small and thin it is. I use a Prime Tower, but it is small. Possibly not necessary but helps sometimes.