About this 3D model

These are some simple desiccant holders that fit inside the spool cavity. I couldn't find exactly what I was looking for, so I made something myself. Here are the features I focused on: Tool-less installation Container grips and rotates with the spool Container fits within existing spool dimensions Cap marked with “C” so its clear which side needs to be unscrewed when desiccant beads need to be removed for drying Container fill markers (25%, 50%, and 75%)* *A partial fill allows the cup to act as a tumbler and mix the beads, so they all have an opportunity to absorb moisture roughly equally. With a full fill, the center beads may not provide much drying. Instructions for use: Pass base cup through the underside of the spool Holding the underside of the spool and the inserted cup, fill with desiccant Insert cap from top and screw down Release supporting hand and use finger grips on either side to tighten If tightened down properly, the container should grip the spool, allowing it to rotate with the spool and tumble the desiccant beads as it rotates in the AMS. The container is intended to live with the spool, so the spools can be loaded into the AMS or stored without removing the desiccant. NOTE: It has been brought to my attention that the printed bambu spools are not the same size as the reusable spools bambu sells. I have uploaded additional files for the printed bambu spools.