About this 3D model

May the odds be ever in your favor…… Artwork of the Mockingjay from The Hunger Games optimized and hueforged for filament painting! I really like how the the flames turned out on this one. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: Generic Black, Red, Orange, Yellow, White PLA+ filaments Swap Instructions: Start with Black At layer #3 (0.32mm) swap to Red At layer #11 (0.96mm) swap to Orange At layer #19 (1.6mm) swap to Yellow At layer #27 (2.24mm) swap to White for the rest. For makers with a single AMS unit. Print order is as follows: Slot 1: Black → Slot 2: Red → Slot 3: Orange → Slot 4: Yellow → Pause → Slot 1: White You will need to swap out the roll of Black filament in Slot 1 for White. This can be done anytime between layers 3 and 26. I've added a pause on layer 26 in the print profile to help with this. Feel free to remove it when slicing if not needed. For makers without an AMS unit Please use the profile labelled NO AMS. In this profile, the color changes have been replaced with pauses where you should manually change filaments (refer to swap instructions). Need a frame for this? Check out my Low Profile Frame for 20 x 20 Hueforge Prints ! Post your makes and have fun!