About this 3D model

The portable flash softbox produced by Godox is designed to be fixed upon the edge of the Godox S-mount. In order to install it on standard Bowens mount LEDs, I designed this adapter based on the outer rim of the S-mount. The size of the Bowens mount is measured from the standard reflector on hand. The test version shown above was printed using Bambu PLA Basic, set to 6 wall layers and 25% triangle infill. The strength is good so far (although, like other Bowens mount accessories, it is a bit loose). I recommend using a matte black high-strength material, such as PLA-CF. Support needs to be generated at the bottom of the three claws. The uploaded print file already has support surfaces drawn for manually generating tree-like supports. I strongly recommend multicolor printing using breakaways support filament. With around 0.8g of support filament usage and 4 filament changes, you can obtain a clean finish :D This model is licensed under CC BY-NC-SA 4.0. Commercial usage is forbidden. ----- The Godox portable flash softbox is designed to be fixed to the edge of the Godox S-mount. To install it on standard Bowens mount LEDs, I designed this adapter based on the outer rim of the S-mount. The size of the Bowens mount is measured from the standard reflector on hand. The test version shown above was printed using Bambu PLA Basic, set to 6 wall layers and 25% triangle infill. Currently, the strength is good (although, like other Bowens mount accessories, it is a bit loose). I recommend using a matte black high-strength material, such as PLA-CF. In terms of support, the model needs support generated at the bottom of the three claws. The uploaded print file already has support surfaces drawn for manually generating tree-like supports. I strongly recommend using breakaways support filament for multicolor printing. With only around 0.8g of support filament usage and 4 filament changes, you can obtain a clean surface :D This model is licensed under CC BY-NC-SA 4.0, commercial usage is forbidden.