About this 3D model

Installation Video: https://www.youtube.com/watch?v=F7p3gz6KHb4 I wanted to tidy up my engine bay by removing the huge OEM washer bottle out of the way. Cappuccino or aluminium ones were too expensive for a washer bottle and the ones offered online were not as good as I'd want, so I set out to design my one... I ended up completely over-engineer this part with clever interior walls shape to allow printing without support structure. This fits MX5 NA & NB (LHD). RHD under design. Features: - 2 Different sizes for different printer's size (250mm Tall & 315mm tall) - 2L Tank (315mm bed version) - Held in place using M6 Threaded inserts and bolts. - Use the OEM pump and rubber grommet. Use some kind of lube on the grommet before inserting it (It's tight to avoid water leaking). - Print without support (Follow last image or use Bambu Slicer file). - It leaves 10mm between the bottom of the washer bottle and cowl, so water can still flow away like OEM. - Print in PETG or ASA (I printed mine in PETG and it did not leak). - WATERTIGHTNESS WILL DEPEND ON YOUR PRINTER AND CALIBRATION. BOM (Bill of material) - Heated Inserts M6x8x5 (M6, 8mm OD, 5 or 6mm length): https://s.click.aliexpress.com/e/c4lt6xBB - M6 x 5mm up to 10mm Bolt: https://s.click.aliexpress.com/e/c4esV009 Similarly to any other Washer Bottle relocation, you will need to extend wiring about 5cm (For NB1). For NB2 seems like there's no need to extend. Bambu Slicer profiles are included for your convenience.