About this 3D model

Side spool holder - remix Side spool holder, all printed parts No bearings, no PC4-M10 fitting Remix changes: Design change for the bearings on the spool holder, the holes are smaller to fit the round part of the roller Design change for the filament guide: made the hole smaller to fit/block the PTFE tube Changed the print profile Remix info All credits to ‘kenkamm’, who is the original creator of this side spool. Original post: https://makerworld.com/en/models/83957#profileId-89747 Print details: I used the textured PEI plate, cleaned it with soap and started printing. No issue with bed adhesion. But you can definitely use other plates for PLA as well. The roller is printed with variable layer height, as in the original post Only support is added to the roller, the rest prints without support Assembly guide Remove the support from the roller and check for any debris on the small rolling parts. You can use a piece of sandpaper to smoothen this Press/fit the roller in the side spool and add some lube to it. Don't use liquid lube. Remove the metal spool holder from the back of the printer Install the printed side spool mount with 2 x M3 screws Install the PTFE tube guide by first removing the 2 small screws on the printer and inserting with 2 longer screws. Add a piece of PTFE tube from the guide to the printer and you're done Print time and used material: Print time: 3 hours and 40 minutes PLA filament, approximately 95gr If you find my model useful, please like :-) All credits to ‘kenkamm’, who is the original creator of this side spool. Original post: https://makerworld.com/en/models/83957#profileId-89747