About this 3D model

With my last batch of incubated eggs, two of the eggs were cracked when they rolled into each other during the day 20 shuffle. I created this to keep the eggs from rolling around. The ten eggs I used them with all hatched fine, and the chicks seemed to have no problems getting out of the shell/holder. Full-Size Chick Eggs: Print with a brim and pull it off or don't even print the brim Bantam Chick Eggs: Print with a brim and leave it on. It nicely shrinks the opening of the holder Bambu A1 Layer Height .2 mm Supports: No (print flat side down) Raft: No Infill: 15% Filament: Generic PLA Time: 33 minutes 61mm x 78mm x 18mm