About this 3D model

This AirTag holder Design requires a few parts for assembly that I will list below. Best printed at 0.1mm layer height as its quite small and requires a nice curve around the AirTag. PETG or ASA is best if you are going to use it outdoors. Comes in an open top design to show off an AirTag engraving or closed top for full protection. Insert nuts are fairly easy to put in the print, soldering iron only needs to be around 100C and these press in fairly easily. I have supplied ready sliced Gcode for MK3 and Mini that stops at the correct Layer to insert the 4 magnets. Requires: 2 x M2.5mm x 3mm brass insert nuts 2 x M2.5 x 6mm bolts 4 x N52 neodymium magnets 10mm Diameter 1mm thick Optional Mounting Accessories: 2 x Zip ties A keyring 3M sticky pad If you struggle to source the parts or don't have a 3D printer you can buy a MultiTag from my Etsy store