About this 3D model

A few spice racks for the kitchen The old plastic spice containers were yellowed/unsightly. The new spices didn't fit anymore. Drilling new holes wasn't an option, so I quickly printed some holders for the existing rod in the spice rack: The holders fit rods with a diameter of 1 cm. Simply hang them in place and they fit. The print was done in PETG-CF and for testing with a print plate that created a slight texture. Of course, it can also be printed with any other print plate. Print slowly, case fan (on the X1C) OFF! I printed the material quite stable, maybe less is also possible. Of course, PLA and other materials are also possible. Brim and supports are NOT necessary. There are short and long side parts. I lowered the oil bottles, raised the spices. The holders and bases should be universal and interchangeable: Oil holder front side: 66mm wide, 50mm high Salt holder front side 86mm wide, 26mm high (of course also suitable for pepper and other spices) Universal holder 145mm wide, 26mm high All bases have a depth of 90mm (universal holder 95mm) and 2x 5mm must be deducted from the side for the side parts. With a width of 66mm, this leaves 56mm of effective standing space, i.e. the spice jars may be a maximum of 56mm wide. With my X1 Carbon, the parts can be used directly after assembly in PETG-CF. Other printers may require some glue. Boost Me Like it? A boost would be nice :-)