About this 3D model

Frame for a rectengular hygrometer for the X1c from Bambulabs. The point really is, that it can also show the temperature and I had nothing else around. In the picture it is printed with PLA-CF although I do recommend printing it at least in PETG. The reason for this is resistance due to the higher temperatures in the buildchamber…although I am pretty sure PLA will be fine, I have never seen the x1c go over 55 Celsius. Better be safe though. Printed with 01. layerhight, first layer as well. 25 % infill, no supports needed, but you might have to drill out the holes with a 2.5mm drill to clean them up. Have fun printing, please comment if you have any suggestions.