About this 3D model

This is a golf ball trophy I designed for a special hole-in-one golf ball. BOM: 1x Trophy Base 4x Trophy Stems 1x 3 inch by 1 inch nameplate with double-sided sticky pad (purchased) E6000 adhesive or alternative Instructions for assembly: Print 4x of the trophy stems and 1x of the trophy base, and insert the stems into the slots in the base with the correct orientation. No supports are needed. The trophy base was designed to fit a standard 3 inch x 1 inch nameplate. The stems may require a bit of adhesive at the bottom to be secured - I used a small amount of E6000. Shown here, the trophy stems are printed in Inland PLA “Twinkling Gold”. The trophy base is printed in Amolen PLA & Wood “Ebony Wood”.