About this 3D model

Boost Me Boost me for free! Disclaimer: This is not an original Apple product apparently. It is just a case for my Apple Pencil 2/Pro that I made a while ago. You will need 5 neodymium magnets size 8mmx2mm (8mm diameter). Correct size is very important for case snap so please measure the magnets before proceed. *** Note *** Depending on the power of the magnets you can have a easily or harder to remove top cover. There is always an easy way to remove the top part. See the video on the end to find out how!!! I use these magnets from Amazon but any 8mmx2mm magnets should fit. Bottom part of the case assembly Print the bottom part of the case. Take on of the magnets and place it around 6cm away from the top of the pencil (see below). Switch the magnet side if required so to be in the right distance. Put the Pencil inside the case, align it with the magnet and push it so for the magnet to be placed inside the hole. Press so the magnet placed in the hole of the case Final placement of the Pencil magnet Now put a drop of instant glue in the 2 remaining holes of the bottom part as per images below: *** Very important *** Place the magnets with the same direction of polarity in the holes . Their poles should be aligned (same poles should point to the top of the case). Press them enough so to have a small gap between the top of the plastic and the magnet. The gap is just a tiny one but it is very important to be there. Leave the glue to stick for 10 minutes. Top part of the case assembly Place the remaining 2 magnets on the bottom case, on top of the already placed magnets as per images below: Put just a drop of instant glue on the 2 holes for the magnets in top part of the case as per images: Align the top case with the bottom as per image: Press the top part against the bottom part so the magnets fit in place on the top part. Remove the top part and press with your fingers the 2 magnets again so to take their final place. Leave the glue to stick for 10 minutes. Enjoy your magnetic Apple Pencil 2 case!!! See the video below on how to open the case easily :-)