About this 3D model

Simple and sturdy headphone hanger. There are 2 cord clips attached to the side for up to 4.5mm cord (most usb charging cords are 3-4mm). It requires 3 screws to mount to the wall. Sticky tape might work instead but I havent tested it. printing/assembly I used default bambu studio .2mm profile and regular PLA. No supports needed teardrop screw holes are 45 degrees which dont need support cords clips are at 45 degree angle as well Drill holes using the part as a template imperial: I used 7/64 inch drill bit and size 4 screws metric: Not tested but the screw holes in the mopdel are 4mm so guessing 4m screw and 3m drill bit?