About this 3D model

Introduction: This design is originally by user @dpolz_208124 from printales.com . The original design is available under the Creative Commons Public Domain License, allowing me to distribute it further. At this point, however, a huge thanks to the designer and for making his project available. Print Settings: Filament: PLA, PETG or ABS Layer Height: 0.2mm Walls: 6 or more Top/Bottom: 5 or more Infill: 20%, gyorid Support: Yes Speed: Normal speed (used 0.2mm Strength X1C Profile) Post-Printing Processes: After printing, remove the supports. For example, drill a hole using a stepped drill bit until the refill cap fits into the hole. Secure the cap inside the hole with a compatible adhesive. Optionally, use a seal approximately 19-21mm in diameter on the refill cap plug. Changelog: 12.01.2024: After one good print, I ran into some issues, so I had to edit the print profile. added XY hole and contour compensation for a better fitting of the two parts increased perimeters (using the Bambu Studio 0.2mm strength profile) modified the Infill density and pattern set support to manual now, the profile contains settings for PLA, PETG, and ABS plates.