About this 3D model

EN: Hello gardener, or panda..? I wasn't happy with the original insert so I decided to make my own. Also, I couldn't find a variant anywhere on the internet that would support a portrait box (the components didn't spill out and 50% of the print wasn't air. While creating it I ran into a lot of variability in how you store the components and whether you are a sleever or not :-) . In the single variant you will find here: - IrrIgatIon channel tray - Hexagons tray (it can accommodate both base and expansion hexes) In the attachment you will also find a tray for 3D printed tile holders https://www.printables.com/cs/model/36702-takenoko-tile-holders-and-irrigation-channels in two versions: - V1 is a hexagon and the holders can only be seated one way (see photo). - V2 allows the holders to be stacked mirror-like, thus increasing the volume of the box (not tested) The models also include a token holder for the two versions: - V1 has larger rectangles for figures, e.g. for filling with cushioning foam (see photo) - V2 has smaller rectangles for the figures, so that they move less during handling (not tested) With the two versions there is also a bamboo trays : - V1 is deep and after printing I had to fill it to make the bamboo higher. But maybe someone will like it. - V2 is 2cm lower and filled by bambus should look like V1 in the photos with the filling. As a last one there is a card organizer in three variants: - V1 is in the photos. The cards are loose, the wrapped cards (45x68mm) will not fit. - V2 is V1-3mm, so the cards should move less here (not tested) - V3 is a variant for wrapped cards (designed for Sapphire Azure - Mini European - 45x68mm cards) (untested) I would greatly appreciate it if you could give me feedback on the inserts, especially those marked "untested" - I would delete the note afterwards. Print and enjoy!