About this 3D model

Threaded Dragon Egg Matryoshka matrjoschka матрёшка I stumbled accross the “threaded dragon Eggs” from Tony Youngblood and thought, why not create a Matrjoschka/matryoshka/матрёшка from it. In case you have not seen them: Source: Wikipedia So i tried and figured out the aprropriate scaling.: Yes, i did that in Excel ? So that means: on a typicial Bambu Lab printer, like the A1/X1/P1 with up to 256 mm of bed size+height, it should be possible to print at least 5 iterations. Unfortunately i was only able to print Iteration 1-3, but it should be possible to change the tolerance etc. Cool thing is that the first egg is 100% and the third is 200% Two 100% Eggs will also fit in one 200% egg. Excel sheet is attached. Happy printing and tinkering. Print instructions: First Build Plate includes three versions 100, 142 and 200% sized eggs. the others are named. The last shells are printed seperately due to the size, so the third plate contains 282% (upper and lower half) and the last plates 395%, printed seperately. If the eggs not fit snuggly, try to upscale the print, or: rotate the eggs. The screw will be alligned, but its a pretty tight fit: