About this 3D model

After I mounted an RX diversity module on my Nazgul Evoque V2, I needed to place the second antenna in the front of the drone so that I had a very good signal even on the way back. It's usually put under the cam to have a good signal even when the drone is facing back, but I didn't have this problem since I have the other antenna in the tail of the drone. Mounting it on top instead greatly improves the return reception since it is completely free from the frame. I printed it in PETG. To be used with soft antennae since it goes directly inside the holes. Boost Me If you like my prints, boost me to help me to improve my works. Thanks