About this 3D model

This is a fully featured full length caddy for NetApp DS4243 and DS4246 disk shelfs. Features: Structurally strong caddy that prints without supports and you can print 2 at a time on a single P1/X1 plate. Integrated finger pull to remove the caddy easily. Slot for adding a label so you can quickly identify a correct drive. I designed a sample chip that you can emboss or print in multiple colors for labeling. You can also just cut out a piece of paper that you can insert in the slot. Slot designed for a 45mm x 20mm x 1.5mm part. Print using PETG or some other high temperature resistant material. Basic PLA is not a good option.