About this 3D model

SUMMARY: This is a tool designed specifically for prying back the gasket on a harvest right freeze dryer. By doing this before closing the door, I can get a good seal 100% of the time. Just pry the gasket around the entire seal, and close the door. It will be a little tight, but once it's closed you should have a good seal. PRINTING: I used the following settings in my print profile. Many aren't important, but I try to make the quality and speed in my print profiles to be as good and fast as I can. Only one wall on top surfaces: Not applied 4 Walls for strength Hilbert curve top and bottom surface pattern for a nice grip 10% gyroid infill for a fast, but sturdy print 1.6mm bottom shell thickness (I did this specifically for silk filaments and a few others which like to split when the bottom thickness is low)