About this 3D model

This holder is specifically designed for popular jet flame lighters, which are frequently employed to eliminate stringing from 3D prints. The products are available under various brand names, yet they are identical in nature. This holder is compatible with your lighter, provided the stick / grip has a diameter of ~29-30mm. These lighters are usually accompanied by a separate stand. However, this holder has been thoughtfully designed to work seamlessly with that base, eliminating the need to choose between using the holder and the stand. It's compatible with any stand having a diameter of up to 51mm. I created a standard holder for this type of lighter that does not allow the stand to be attached. You can find it here . To ensure exceptional stability, I have integrated custom-designed Skadis hooks with minimal tolerances into the design. It's important to note that these hooks do require supports while printing. Printing Instructions The print profile is optimized with zero layer cooling and no cooling for the initial three layers, effectively reducing the print time by nearly 50%. If you experience any difficulties, reverting to the standard PLA settings is recommended as a troubleshooting step. I recommend using brims due to the relatively thin brackets. Lock Plug Due to the increased forces compared to other accessories, I recommend using the Skadis Lock Plug in 10mm to prevent the holder from sliding out of the pegboard holes when you retrieve interact with the holder. Depending on your print settings, filament and board, you might have to choose another size . Skadis Collection I am constantly developing more IKEA Skadis attachments. Check out my IKEA Skadis Collection here .