About this 3D model

This holder is capable of accommodating up to four one-handed clamps, each with a depth of approximately 35mm and the angle of the legs is 53.5°. While I designed it specifically for use with Wolfcraft clamps, it should be compatible with any clamps that fit within these specified dimensions. To enhance its versatility, I've included three unpartitioned slots in the design. Printing Instructions Given that the holder is subjected to relatively low stress, it can be printed with minimal infill. I achieved good results using 15% cubic support and 2 perimeters. Should you opt for a lighter filament, consider increasing the number of perimeters to prevent any potential transparency issues. Skadis Collection I am constantly developing more IKEA Skadis attachments. Check out my IKEA Skadis Collection here .