About this 3D model

I found one promising mount to make Kingroon KP3S Pro S1 a printing beast. I like the MAD system for BIQU H2 V2S and was desperate to work with my unit. The original model that I found was not quite working so I made the following edits: cut at a specific height to not crash with MAD ducts the bottom part of the model where the thermistor wires are placed is little bit wider to fit in I moved the extruder mount from top to bottom (as the MAD base needs to be attached at the top) model width was reduced to not interfere with the MAD base fan cover was moved 2 mm to fit tight to the heat sink fan added a mount to zip-tie the heater wire in place and not rub the X-rail The MAD base needs to be cut 1 mm at height.