About this 3D model

printed holster for the diana, you will need 2 m3x6mm screws to attach the retention clip. The holster should be printed out of pla or another equally stiff material with a large number of walls and a brim as the surface touching the bed is rather small. The clip and the molle strip can be printed from pla but the clip should ideally be a more heat resistant material like petg as it sits right on the hot motor heatsink and could soften. fits on all the molle gear I have but can be a bit of a pain to put on. not verified to fit with an optic on top but there is a good amount of room, if your optic stays behind the rearmost screws for the flywheel cage and doesn't hang off the edges very much I think it will clear.