About this 3D model

Hotend mount remix for xol_toolhead and bambulab hotend. In addition to the standard elements that are described on the xol_toolhead github page, you need a few additional screws to attach the hotend to the toolhead: 2x M3 heat inserts 2x M3x10 (for screwing the upper part of the hotend heat sink) 2x M2x10 (screwed into the radiator from the back) Standard air ducts should be used for this hotend mount, the version with LEDs also works. Print the model on its back, it is necessary to use supports. Remix was created for a clone of the Bambulab hotend from Aliexpress, in which the nozzles can be easily replaced. However, if you want to use the original bambulab hotend and be able to replace hotends relatively easily, do not screw in the left M2 on the back. Then, to disassemble the hotend, you will not have to disassemble the toolhead from the printer, just unscrew one screw at the back and two M3 screws after unscrewing the left fan, unplug the connectors and slide the hotend down.