About this 3D model

This is a two piece mount for a GoPro clip in adapter to mount in a Porsche 718 Cayman. Slide the clamp over the bar behind the seats push in the clip and the slide in the GoPro adapter. It doesn't wobble and shouldn't slide. if it is a little loose the you could possible add a strip of electrical or similar tape to the inside of the clamp to reduce the clearance. The one shown was printed at 0.35 for speed but I would recommend 0.2 or lower if you want it to look good. The parts should be printed vertically and don't try and print too fast or it will most likely knock the part over on the print bed. I have added plain versions of each part without logos Print instructions Category: Automotive Summary This is a two piece mount for a GoPro clip in adapter to mount in a Porsche 718 Cayman. Slide the clamp over the bar behind the seats push in the clip and the slide in the GoPro adapter. It doesn't wobble and shouldn't slide. if it is a little loose the you could possible add a strip of electrical or similar tape to the inside of the clamp to reduce the clearance. The one shown was printed at 0.35 for speed but I would recommend 0.2 or lower if you want it to look good. The parts should be printed vertically and don't try and print too fast or it will most likely knock the part over on the print bed. I have added plain versions of each part without logos Update Dec '23 - I have added files for printing in colour however they still need printing end on. The colour files are Mount, Cap, MountNumbers and CapLetters. Print Settings Printer Brand: Prusa Printer: i3 MK2S Rafts: No Supports: Yes Resolution: 0.2 Infill: 30 Filament: any PLA / PETG Grey