About this 3D model

I was searching for an enclosure to house my ESP8266 NodeMCU CH340 ESP-12E Development Board, which I will use for a WLED project. I did not find anything suitable or to my liking. I wasted time looking at different enclosures only to find they were not the right dimensions so I decided it would be quicker to design my own. Enclosure features: No screws required, snap-fit lid with a cutout to easily pry open lid Cutouts for micro USB, Dupont or similar connector, 8266 Flash and Reset button access PCB standoff blocks and pins with no requirement to screw down Small form factor 65(L)x38(W)x16.35(H) mm PCB hole spacing at 25mm x 52mm I used supports for cleaner cable cutouts but they aren't critical Easy and quick to print Dimensions available in pictures to see if this enclosure is suitable fo you