About this 3D model

This is a diy masturbator using a latex glove (or a condom if you feel fancy) and some big sponges. Bill of materials: 2x big sponges (140x90x40) a latex glove this 3d printed model rubber band (optional) lube! Notice: the glove is single use, before using this again you have to disassemble everything, throw away the glove and let the sponges sit uncompressed or they will retain the shape long term. Assembly instructions: Gather the materials Flip the glove inside out (there is powder for sweat inside gloves, we want to use the clean side) Tie a knot on each finger leaving only the middle finger since it's the longest, tie the knot higher than you think or it'll pull on the latex Place it in the middle of a sponge and sandwitch it Pull the large side of the glove so that you have enough glove sticking out, now you can also wrap around rubber bands for tighter sections as you prefer Prepare the 3D printed part, make sure to align the sponges exactly like in this photo Compress the sponges with your hands and stick them inside the hole, the long side of the sponge should be where the short side of the 3d print is (to make the hole in the middle) also the large part of the glove should be where the thick edge of the part is Push it all the way inside Wrap the glove tightly around the plastic lip Pull on the other end of the glove to catch the slack and cut a hole in the finger to let air move in and out, you might want to fill the sponges with warm water if you are fine with dealing with damp sponges when cleaning up afterwards Enjoy, don't forget to use some lubricant since bare rubber is very unpleasant, use silicon- or water-based lube fo the best experience or search online for alternatives