About this 3D model

This is a remastered Kyosho Blizzard V2.0 interior, accommodating: Two motors Two ESCs Two Inter-ESCs One 3S battery One Spektrum receiver One 5V power supply One snowplow servo One tiller servo One tiller switch A magnetically secured body shell for convenient access A rear-mounted load plate, adaptable for future winch installation A designated camera mounting location Beyond component printing, you will require: Twenty 8x4x3 mm neodymium magnets Ten M3 heat-set inserts Approximately twenty M3 screws of varying lengths (5, 8, 12 mm) This design necessitates no drilling, cutting, or modifications; simply unscrew components. Assembly proceeds as follows: Completely remove all existing electronics from the Blizzard Install the motors, unconnected to ESCs Install the base plate—pre-fitted with inserts—securing it to the chassis with screws Install servos, receiver, ESCs, and power supply, routing cables through designated apertures in the central plate Attach the central plate to the base plate using M3 screws, ensuring cable clearance Adhere the XT60 connector Route interconnects and power cables through the inner cover, then fasten it to the central plate Secure the switches using the provided component and attach to the cover Affix the tiller switch support and secure in its designated location Connect linkage rods to the servos With the foundation complete, calibrate servo throws and wire motors to ESCs Bodywork installation: Affix magnets to the body mount apertures (ideally, maintain consistent polarity) Secure body supports along the chassis, fastening them with existing M3 screw holes Adhere magnets to the body shell (confirm polarity compatibility with the body mounts) Attach the original body cab to the front section (the 3D-printed aperture accommodates original screws) Adhere the load plate to the rear body Affix magnets to the motor guard (verify polarity before adhering, to avoid reprints) Enjoy your readily accessible, 3S-capable Blizzard 2.1