About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm You can complete this print without an AMS. Use the profile that says NO AMS and it will pause at the correct height instead of doing a filament change. At that point you change your filament and let it continue until the next pause where it will wait for the next manual filament swap. This being a three color Hueforge, it will require two pauses with manual filament changes. Filaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA+ IIID Max Orange Transmission Distance: 4 PLA+ Sunlu White Transmission Distance: 5 Swap Instructions: Start with Black At layer #13 (1.12mm) swap to Orange At layer #35 (2.88mm) swap to White for the rest.