About this 3D model
Fan-made replacement flag models for the classic fantasy tower board game.Includes board and tower variants with printing guidance. This upload contains fan-made functional replacement flags for the original Dark Tower board game. They are intended for repair and restoration of broken or missing flags commonly found on original sets. No artwork, logos, or symbols are included. Two STL variants are provided to correctly match the different flag mount locations used on the game board and on top of the tower. Included Files:1: dark_tower_gb_flag.stl — Board Flag Variant (Regional Flags) Designed for the standard regional flag holes on the game boardReinforced insertion peg below the retaining collar for improved durabilityFits snugly in original board holesPole is intentionally slightly taller than the original for improved visual balanceFlag width and waving area align with original artwork/sticker dimensions (within 0.8 mm nozzle tolerance) 2: dark_tower_twr_flag.stl — Tower Flag Variant Designed specifically to fit the flag hole at the top of the towerSlimmer insertion peg below the retaining collar to match the tower holeShared visible geometry with the board variantPole height matches the original tower flag height (within printing tolerances)Validated for proper fit without forcing or wobble Note: The board flag variant (dark_tower_gb_flag.stl) will not fit the tower hole correctly. Please choose the appropriate file based on the flag location you are replacing. Also Note: Allow the print to fully cool before removing it from the build plate. Use pliers or a similar tool to gently separate the tree support structure from the bottom of the flag post. Removing supports while the part is still warm can apply torsional stress and may break the insertion peg. DisclaimerThese files are provided as-is. Fit and tolerances may vary depending on printer calibration, material, and print settings. The author is not responsible for damage caused by improper printing, scaling, or forceful installation. Do not force parts into place. Test fit carefully before full insertion. Setup:Print orientation: Upright (flag pole vertical) Supports: Required- Supports from build plate only- Tree / organic supports preferred- Supports will contact the underside of the waving flag and the retaining collar Filament: PLA or PETG recommended Post-processing:Allow the print to fully cool before removal.Carefully remove supports from around the insertion peg and retaining collar.Test fit gently — do not force parts into place. If this repair helped you consider showing your support with:Buy me a coffee