About this 3D model

Circular Hygrometer/Thermometer Printer Mount This mount is compatible with P1P/P1S/X1C/X1E. I can only recommend the profiles I created (“Designer” print profile) for the best results. Print using a filament that can withstand high temperatures (NOT PLA!), I used ABS, however, PETG should work just fine. No support or brim is needed. Here's the device I'm using, however, you can get the same from Amazon or other places. Search using the keywords “digital hygrometer thermometer”: https://a.aliexpress.com/_Evc7mN3 *Update - 24th January 2024* Thanks to the feedback from @uberroot , I have now added the “Short_Hygrometer_Mount” print profile, it has a much shorter stem compared to the first model ("Hygrometer_Mount"). While I didn't personally need this as I only use this setup for pre-heating the chamber, the updated mount allows you to view the hygrometer much earlier as the print continues and the build plate goes down. 1. Importing: Import the 3MF file into the slicer and make sure the selected settings are correct ( video below ). I have already set the correct settings for the 3MF file, but it is a good practice to verify, and you still have to select your printer if it's not a P1S. 2. Post-processing: After printing, use side cutters or, for a cleaner cut, flush cutters to trim the tip of the mouse ears (brim ears). You can also optionally sand down the edges for a smoother finish. 3. Installation: Just place the hygrometer/thermometer into the mount and clip the mount over the side rail of the printer as shown below. Thank you for printing, please provide feedback and share your results! ?