About this 3D model

Support the designer: Donate Bitcoin here: bc1q9mhh7l53mmlnqqmazdnr6gele0smrzkunclfvj Donate Ethereum here: 0x36CA6EEF3700ff18858f195706C5E3A9d6458241 This design is a simple latch point that you can clamp with 2 x M3 screws and heat inserts to other things. Example : I designed it so that I could add two hook point to my snowboard carry bag so that I could clip on shoulder straps and carry it like a backpack. Bill of materials : M3 heat inserts (OD 4.2 mm and 10mm length) . (2 needed per hook clamp set: part 1 + 2) M3 screws (12mm length) . (2 needed per hook clamp set: part 1 + 2) Print instructions : print hook point part ( part 1 ) with hook point up. This is to print the holes well sized for the heat inserts. Another orientation might change the size of the holes. print clamp part ( part 2 ) on its side. Use an outer brim Build instructions : inset the heat inserts with a solder iron. insert both parts around object to be clamped (preferably fabric / rope) screw in both screws at the same time.