About this 3D model

Boost Me You like the Design? Consider using your boost tokens to help and support me for free! - Want to earn easy reward points? Rate the print profile by going to the Rating link on your Profile drop down menu. - My own link is https://makerworld.com/en/@neocrisis/rating Summary Here is a lithophane for a Siberian Husky I am now uploading two versions. No Base: It has a 3mm thickness and a 3mm border around it. I have had issues with my print not staying stable and wobbling a bit towards the top of the print. Has Base: It has a 3mm thickness and a 3mm border around it. Add a base of 7mm which makes the total base of 3mm (thickness) + 7mm (base added) = 10mm The inclusion of a base has benefits; more stable print towards the top Its now a free standing print, leave by the window you can put your contact info at bottle of base but not affect image My printing dimensions; height is 75% of width Thus, if the width if 120mm, then the height I use would be 90mm. I like printing my pictures standing up, I personally think it looks better. I tried printing a image flat....it looked very very bad. I personally will not try it again. I suggest using 100% infill to remove as many air gaps as possible, you do not really use much material anyway. You should use a brim to print this, I tried a raft but because the image is tall, it was not able to stand up straight and the print failed. I am the owner of https://www.neocrisis.com