About this 3D model

Boost Me You like the Design? Consider using your boost tokens to help and support me for free! - Want to earn easy reward points? Rate the print profile by going to the Rating link on your Profile drop down menu. - My own link is https://makerworld.com/en/@neocrisis/rating Summary Update 2/5/19: After several weeks of testing, it seems I need to increase the clip length to 200% in Cura (Uniform scaling turned OFF!) . This is because the clips tend to popped off. I will update this later to see if this fixes my issue I have nothing against a belt but they are a rather pain to use. You need to tighten them Need to loosen them to go to the bathroom Thus I designed a simple clip that allows you to tighten your pants without needing to use a belt. My design for jeans, I have not tested in on non-jeans. Info I used a 10% infill I printed two for myself, I could print more if needed Other I suggest you sand the sides of the clip I printed my clips in grey because thats the color I had, but if you print them the color of your pants, maybe people wont notice it I see no reason to remove the clips from pants when the pants not in use. There are 3 "slots" in the design, with the jeans, i was only able to use the outer two slots because jeans were hard to put into all 3 slots. This is the reason I use 2 clips, however I would guess if you use this clip on more flexable material, you should be able to use all 3 slots I am thinking I will make a version for animals. The harness for my dog, Loki, is rather loose. Thus, I want to try using this design was a way to tighten up his harness. I am the owner of https://www.neocrisis.com