About this 3D model

Update 05/03/25: Updated the 123mm Offset profile to resolve print quality issues reported. Print with at least .16mm layer height! Printing at .2 or higher may result in low quality overhangs This is a cupholder adapter for using a huge water bottle (64 Oz.) in your car. For a smaller cupholder adapter, please see my other design here . This was specifically made for a Dodge Charger, but it will fit any cupholder with a 74mm diameter. This base is 74mm wide and 65mm tall before widening out to accommodate 123mm wide bottles at 85mm height. The base is also hollow to prevent vacuum suction and can also hold 70mm wide bottles/cups as show in the pictures (medium takeout cup). There is both a centered and offset profile. If your car's cupholder are close together, the offset is likely better to be able to use the other one in your car. The water bottle pictured is a RTIC 64 Oz. water bottle Centered Cupholder Dimensions: Base Outer Diameter: 74mm Base Inner Diameter: 70mm Base Height: 65mm Widened base height: 85mm Top Outer Diameter: 127mm Top Inner Diameter: 123mm Top Height: 60mm Offset Cupholder Dimensions: Base Outer Diameter: 74mm Base Inner Diameter: 70mm Base Height: 59mm Widened base height: 85mm Top Outer Diameter: 127mm Top Inner Diameter: 123mm Top Height: 58.5mm Confirmed Vehicle Fitment: Cadillac XT4 Dodge Charger Dodge Caravan Toyota Rav4 Chrevolet Silverado If it works for your vehicle, let me know in the comments!