About this 3D model

This is my valentines heart box! Fill the box with lots of love and gift it to a loved one! The box has print in place hinges and holds together with magnets. It opens and closes lightly, there is no handle necessary. You need per box: 6x3mm magnets 4 pcs. a few drops of of your preferred glue to glue in the magnets a bit of masking tape to mask the outside of the box at the area where you will glue in the magnets, so you don’t spill the glue I designed the box in different variations, with four, two or zero compartments, with amor on one side and a blank bottom, with amor and “i love you” or without amor and only “thank you”. This means you can find the right choice for every situation. Print instructions: layer height 0,20mm 2 wall loops top/bottom shells 4 layers top/bottom shell thickness 0,80mm sparse infill 10% sparse infill pattern “gyroid” Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. Repeat the process every 5-6 prints. Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design. Please check out my other models and leave me a like if you were satisfied with the model and the print. Thank you in advance!