About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.20mm If you don't have AMS simply replace all “color change” in the sidebar with “pause” instead and all layer heights are then set. Otherwise use the settings below. Filaments Used: Sunlu PLA+ Black Azurefilm PLA Wine Red 3DE PLA Chilli Red 3DE PLA Flame Orange Sunlu PLA+ Yellow 3DE PLA Light Grey Swap Instructions: Start with Black At layer #08 (0.76mm) swap to Wine Red At layer #11 (1.00mm) swap to Chilli Red At layer #14 (1.24mm) swap to Flame Orange At layer #18 (1.56mm) swap to Yellow At layer #21 (1.80mm) swap to Light Grey for the rest. If you scale, make sure not to change Z height.